Contact us for online assistance
How to install an air-conditioner
Installation of an air-conditioner requires a professional who will observe all safety instructions and guarantee the correct assembly of the unit and its effectiveness.
Follow the steps, if you want to secure proper and safe installation:
1. Connection of the condenser
The condenser is a crucial part of the block. It transforms gas into liquid by cooling. The condenser must be in a place that is at a suitable level and is clear, out of direct sunlight. Assemble it on a dry wall.
Place the condenser close to the panel. Connect it to the circuit system to facilitate wiring. Install it away from trees, so it has a normal airflow. Make sure it is at least one meter from electricity or gas.
2. Installation of pipes and wires
To finish this step, make a sufficiently large hole.
3. Installation of the evaporator coil
The placement of the coil is another step of the installation process. Make precise measurements, as well as drilling and cutting pipes.
4. Installation of cooling lines
The alternating current must have two lines for the refrigerant. So it can provide a connection from the condensing block to the evaporator coil. The lines connected to the capacitor must run inside the house to the coil.
5. High voltage connection
You should use the service of a skilled professional, because of the high voltage danger. The air-conditioner works with 220 volts. Therefore, wire a connection between the main electrical panel of the house and the condenser.
6. Low voltage connection
The connection of the capacitor is also a crucial part of the installation process. It requires a low-voltage connection. This includes working with the thermostat and other smaller units. Route the wiring through the previously cut hole.
7. Installation of the drain pipes
These pipes connect the outer and inner body. They provide the daily work of the refrigerant, as to reach the desired temperature in the room. Connect the pipes to the coil of the heater. Thus, the condensation from the coil will drain out.
8. Hermetize the air-conditioner
Back-up of the front gap prevents the optimization of the entire system and secures the highest efficiency. For this purpose, it uses a vacuum pump, and the process takes no more than 20-30 minutes, depending on the length of the pipe.
9. Installation of a drip tray
Don’t forget to drain the air conditioner in a drip tray. Inside you can place a heater with a thermostat, which does not allow the water to freeze during the winter.
How to assembly an air-conditioner:
Connect the condenser |
Install pipes and wires |
Secure high and low voltage connection |
Hermetize the air-conditioner |